After having already re-written it once, here's the response I received to the 2nd submission of my critique of exhaust wrap:
"Our staff has read your review and values your contribution even though it did not meet all our website guidelines. Thanks for sharing, and we hope to publish next time!
Submit something new
Thanks again,"
JEGS
Here's what I wrote. Please tell me if I'm being unfair...
What a Pain!
I purchased this wrap last Fall and just now had a free weekend to pull off the header and wrap it. I watched the DEI instructional video on U-Tube, pausing it at each step so I understood how the wrap was correctly applied. The wrap unraveled faster than I could wrap it around each pipe. And, even though I meticulously followed the video instructions for measuring, I always came up short and had to start over several times. Don't believe the "... 1/4" overlap..." on the video, you will need at least a 1/2" or you will end up with 'bare' spots where the wrap doesn't cover. As for the stainless steel ties, good luck getting them tight enough to hold the wrap. Also, 35' is not enough wrap to cover all four pipes of my 2.3L Ford engine header on my project. I got only three wrapped, so now will have to buy more to complete the job. Which, right now, looks like {Expletive}. So, maybe I'll do something else.